![]() ![]() If the pressure is too high, release air by pushing on the metal stern in the center of the tire valve.ĥ) Measure the tire pressure again with the tire gauge.Ħ) Be sure to place the valve caps back on the valves to help prevent leaks and keep out dirt and moisture. The lower ambient temperatures allow tires to be more efficient at. Additionally ambient air temperatures in winter typically range 40- to 50-degrees Fahrenheit colder than typical summer temperatures for the same location. If the reading matches the recommended pressure, you are done.Ĥ) If the pressure is too low, add air until you reach the recommended pressure. In most of these cases, 40 psi should be more than enough, and since most modern tire designs will allow up to 44 psi (in some cases more) this is not a problem. The 3-5 psi higher recommended inflation pressures increase tire stability and help offset the reduction in responsiveness. Do not rely on the gauge on the air pumpĢ) Remove the valve cap from the tire valve.ģ) Press the tire gauge onto the valve to get a pressure measurement. You cannot tell if your tires are properly inflated simply by looking at them. However, if you have a high-performance variant of the Civic, you might need a slightly different tire pressure. To confirm this, you can check your owner’s manual or the sticker on the inside of the door frame on the driver’s side. ![]() ![]() Here’s how:ġ) Prepare a good quality gauge to check tire pressure when the tire is cold. In most cases, the recommended tire pressure for a Honda Civic sedan is 32 psi for both front and rear tires. So you should check your tires at least once a month. Unevenly worn tires can cause poor handling, loss of vehicle control, and sudden tire failures which could potentially lead to accidents, injuries, and even death. Tires with too much or too little pressure wear unevenly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |